Zliccio Table Lamp
Zliccio Table Lamp
The Zliccio table lamp pairs simplicity with modernity. A stack of glass spears coupled with wood makes up the stem of the fixture, while the shade is kept simple letting the lamp truly shine. The large shade diffuses the lighting, gently casting illumination on the glass below as well as lighting the surrounding space. Available as table and floor Lamp
Fixture Material: Glass & Wood
Shade Material: Fabric
Assembly Required: No
Fixture Color: Brown
Shade Color: Cream
Light Direction: Ambient
Switch Type: On/Off
Bulb Base: E27
Recommended Bulb: LED
Bulbs Needed: 1
Maximum Wattage: 40W
Cord Length: 150 cms
Cord Material: PVC
Width: 18 cms
Length: 18 cms
Height: 48 cms
Weight: 2 kgs
1 Zliccio table lamp, Bulbs and accessories not included.
Living, Dining, Bedroom, Hallway, Deck
Dirty light fixtures can emit up to 20% lesser light than clean ones, so regular cleaning and dusting go a long way toward brightening your living spaces.
For safety purposes, never attempt to clean or work on a lighting fixture with an active electrical current. The best bet is to unplug fixtures or turn off the circuit breaker prior to cleaning. Also, never allow liquid to touch wiring.
In case the glass globe/shade can be removed; support the glass firmly with your hands while you remove the screws or clamps holding it in place. When you've safely removed the glass from the fixture, dump any dirt or dead bugs out into the trash and fill a bucket or your sink with warm, soapy water. Soak the glass in the water for a few minutes.
Also, do take a look at the light bulb(s) themselves and determine if they need any attention. If your bulbs have a dirty film on them, your room may be getting less light than it should be! Using a damp cloth, very gently wipe any residue from your bulbs and allow the bulbs several minutes to dry completely. Replace the bulbs into their fixtures.
After soaking the glass for a few minutes, use a sponge or cloth to wipe away any remaining grime, then dry it completely with a towel. Replace the glass with the screws or clamps.
If you can't remove the glass or would rather clean them in place, be sure to spray any water or cleaning solution onto a cleaning cloth first, not directly onto the fixture!
Dust with a slightly damp, soft, lint-free cloth. Once a month ,clean the surface with a clean soft cloth dampened with a quality cleaner formulated for wood furniture. Wipe dry with a dry, soft cloth in the direction of the wood grain. Also, do not use polishes containing waxes or abrasives or polishes that are oil based. For minor repair of water rings, stains, and scratches; rub the surface lightly in the direction of the wood grain using steel wool. Apply a scratch-removing polish with a color and value that simulates the wood color if required.
Fabric shades are typically subjected to common cleaning maneuvers with vacuums or dusters, though they are easily dented, scratched or discolored. So it is important to clean them properly and carefully.
Usually in a fabric shade the softer material is wrapped around a plastic skeleton, so getting it wet is not a problem. However, if too much pressure is applied, they can easily dent and if sharp or metal objects are used, ripping and scratching can occur. So the cleaning has to be done with minimal pressure. Because this material is compatible with moisture, a kitchen sink or bathtub can make the perfect spot for cleaning. You can certainly do something more quick and simple to remove any surface dirt with a cloth or duster, but for a thorough cleaning, try some soapy water, light scrubbing and a gentle rinse to make it look like new again.